Download the catalogue and request prices of Logamatic By buderus, heat regulation and hygrometric control, logamatic Collection. Manuals and User Guides for Buderus Logamatic We have 1 Buderus Logamatic manual available for free PDF download: Operating Instructions . View and Download Buderus Logamatic operating instructions manual online. Logamatic Control Unit pdf manual download. Also for: Logamatic.
|Published (Last):||9 May 2005|
|PDF File Size:||6.7 Mb|
|ePub File Size:||6.47 Mb|
|Price:||Free* [*Free Regsitration Required]|
All heating circuits without an MEC2 continue to operate normally. First, the heating circuit whose temperature you want to adjust is displayed. It changes logamatid between day mode standard mode and night mode setback mode. If you wish to delete a heating phase, both switching points must be deleted. Page 26 2 seconds. However, raising the flow temperature does not raise the room temperature, as the thermostatic valve continues to limit the room temperature. Modules and their functions 9 9 Modules and their functions The following lists all the modules that are or can be fitted in Logamatic x control units.
In emergency mode, all pumps continue to run and the mixers are volt-free. Hold down “Heating circ.
Buderus Logamatic Control Unit | eBay
Got it, continue to print. FM function module accessory. The set temperature is displayed via an LED next to the rotary selector. Either one of the factory-set permanent displays is shown, subject to whether the MEC2 is fitted in a control unit or is logamaatic as a wall mounted unit.
Selecting The Operating Mode Chapter 6. Open windows three to four times a day for approximately 5 minutes. If required, your heating contractor can alter these settings.
A heating program provides automatic changeover between operating modes day and night mode at fixed times. At loyamatic level, proceed according to the “Push and turn” principle. Manually disconnect the heating circuit mixer and position towards hotter or colder, until the required room temperature is achieved. After modifying the temperature, reset the operating mode to the previous setting.
The primary and secondary pumps and the DHW circulation pump are switched off.
Press “Weekday” again to enter the year. The display shows “Constant summer”. When no blocks are left both heating phases have been combined.
Plug it into the r. The switching point has been deleted when no blocks are left. The burner combusts fuel e. The display briefly logamatid the heating circuit.
Set time Release “Time” to save your input. You can modify the operating mode of DHW circulation as follows: Extended functions 7 Press and hold down “Temperature”. Furthermore, your control unit records different variables that influence the room temperature and compensates for these. You have four options for reducing the room temperature via the control unit.
The logamatlc is set in one-minute steps.
The control functions remain active. Manually disconnect the heating circuit mixer and position towards hotter or colder, until the required room temperature is achieved. The more you are aware of the options offered by your heating system, the greater the benefit you will be able to draw from it. Constant winter Logamaticand – Subject to technical modifications.
DHW cool — Switching program is incorrectly set up.
Otherwise, the heated air cannot circulate and heat the room adequately.